Sizing Guide

Maternity clothes are cut to accommodate your changing figure. In most cases you should order the same size you wore before you were pregnant.
Following is our general size chart used for most items and some specific designer size charts.

General size chart: (Remember to go by your pre-pregnancy size)

X-Small Size 0-2
Small Size 2-4
Medium Size 6-8
Large Size 8-10
X-Large Size 10-12

Annee Matthew sizing chart:

The following table contains sizing information to help you obtain the best fit. Please refer to appropriate size equivalents and hip and bust measurements to determine your optimal size. This chart is applicable for bra sizes A-D. If you are a DD/E, please order one size larger than what is indicated on this chart.

Pre-Pregnancy Size: Current Bust: Current Hip: AM Size:
0-2 Up to 34" 36" X-Small
2-4 Up to 36" 38" Small
6-8 Up to 38" 40" Medium
10-12 Up to 40" 42" Large
14-16 up to 42" 44" X-Large
18-20 up to 44" 46" 2X
22-24 up to 46" 48" 3X

Nursing Bras:

  • Measure around your rib cage just beneath your breasts.
  • Be sure that the tape is level from front to back and parallel to the floor.
  • If you’re in between sizes, the smaller band will usually offer better support.

Rib Measurement   Band Size

29″-32″                     34 band

33″-34″                     36 band

35″-39″                     38 band

39″-41″                     40 band

42″-43″                     42 band


  • Measure around the bust at the fullest point while wearing an unpadded bra.
  • Each inch of difference between this measurement and your band size = a cup size.
  • If your band size is 34 and your bust measurement is 36″, you wear a B cup.
If the difference is: 
2 inches                   B cup
3 inches                   C cup
4 inches                   D cup
5 inches                   DD cup
6 inches                   E cup
7 inches                   F cup

Belabumbum size chart:

Size: Bust: Cup:
Small 32"-36" B-C
Medium 36"-38" C-D
Large 36"-40" D-E

If you are still unsure of what size to order, please contact us at